2. Check the wall outlet and also the power plug adapter if there is....to make sure it is not a loose connection issue.
3. Check at the back of the printer.. make sure plug is properly inserted.
4. Try to remove other connection, only the plug and observe.
5. Perform a hard reset on your printer.. Unplug all connections from your printer...press the power on to completely drain the power volts....leave it unplugged for thirty minutes..turn the printer on. Observe if the the problem will still persist after few hours of operation.
6. If above suggestions did not work, bring the printer to the nearest service center to fix the power supply board and logic circuit board inside your printer. Most of the times, spilled waste inks on the circuit boards caused this kind of problem.
Good Luck!
No comments:
Post a Comment